Graco hoses represent the benchmark that all others strive to
achieve in the spray foam industry.
Graco's hoses offer many firsts in the spray foam industry such
as the Fluid Temperature Sensor (FTS) as well as different A
and B side connections to avoid cross over. With the wide selection
of sizes, pressures, and lengths CPi will be able to outfit
any hose requirement that could arise.
HEATED Hose
JUMP TO FEATURES
JUMP TO TECHNICAL
JUMP TO
SETUP
Features
State-of-the-art design gives the Graco hoses
superior performance in the plural-hose market
Graco's Unheated Hoses are the same high-quality, durable hose
as the heated design with the exception they are unheated. If
your application allows for unheated hoses Graco provides the
most reliable and technologically advanced hoses.
-
Available in different pressure ratings, lengths, and diameters.
-
Different fittings on the A and B sides to prevent incorrect
connections.
-
Very low permeability to avoid crystallization and/or other
chemical reactions of the materials in the lines.
Back
to Top
TECHNICAL
Components and details of a Graco Heated Hose
System
-
Fluid Temperature Sensor (FTS)
-
Fluid Temperature Sensing cable
-
Hose assembly cable
-
Heated hose wire
-
Air line
-
Fluid hoses
-
Ground wire
Back to Top
SETUP
There are many different ways you can setup your
heated hose system. FoamWorks has picked a few of the most common
methods and outlined them below.
2000/3500 psi 150 ft. Hose System (normal flow)
-
Two 50ft lengths of 3/8" Heated Hose with Thermocouple
Wire
-
Fluid Temperature Sensor
-
50ft length of 3/8" Heated Hose
-
10ft length of Whip
-
50ft length of Scuff Jacket
2000/3500 psi 300ft Hose System (high flow)
-
Two 50ft lengths of 1/2" Heated Hose with Thermocouple
Wire
-
Three 50ft lengths of 3/8" Heated Hose with Thermocouple
Wire
-
Fluid Temperature Sensor
-
50ft length of 3/8" Heated Hose
-
10ft length of Whip
-
50ft length of Scuff Jacket
Back to Top
|
