FoamWorks Spray Insulation

Welcome to FoamWorks Spray Insulation - Suppliers of Spray Foam Equipment,
Spray Foam Rigs and Spray Foam Insulation Products include Biobased Spray Insulation!

Tel: 01 298 7519
Fax: 01 689 6520
FoamWorks Spray Insulation - Suppliers of Spray Foam Equipment,Spray Foam Rigs and Spray Foam Insulation Products including Biobased!

Graco hoses represent the benchmark that all others strive to achieve in the spray foam industry.

Graco's hoses offer many firsts in the spray foam industry such as the Fluid Temperature Sensor (FTS) as well as different A and B side connections to avoid cross over. With the wide selection of sizes, pressures, and lengths CPi will be able to outfit any hose requirement that could arise.

Choice of Fluid Pressures

  • 2000 psi Spray Foam Rigs
  • 3500 psi

Multiple Lengths

  • 50 ft Heated
  • 50 ft Unheated
  • 25 ft Heated
  • 10 ft Whip
  • 3 ft Whip

Various Diameters

  • 1/4 inch
  • 3/8 inch
  • 1/2 inch
 

Whip Hose

JUMP TO FEATURES

JUMP TO TECHNICAL

JUMP TO SETUP

 

 

Features

Durable design, appropriate length to help increase sprayer efficiency.

Graco's hose design is the most advanced in the plural-component hose systems. The whip hose is designed in shorter heated lengths so that it is easily handled and has fewer components than the heated sections to prevent possible damage. Graco's Whips are available in both 10 ft. and 3 ft. sections.

  • Available in different pressure ratings, lengths, and diameters.
  • They heat quickly using copper-wound technology.
  • Different fittings on the A and B sides to prevent incorrect connections.
  • Very low permeability to avoid crystallization and/or other chemical reactions of the materials in the lines.

  Back to Top

 

Technical

http://www.cpifoam.com/images/hoses-technical.jpg

Components and details of a Graco Heated Hose System

  1. Fluid Temperature Sensor (FTS)
  2. Fluid Temperature Sensing cable
  3. Hose assembly cable
  4. Heated hose wire
  5. Air line
  6. Fluid hoses
  7. Ground wire

 Back to Top

 

 

Setup

 

There are many different ways you can setup your heated hose system. FoamWorks has picked a few of the most common methods and outlined them below.

2000/3500 psi 150 ft. Hose System (normal flow)

  • Two 50ft lengths of 3/8" Heated Hose with Thermocouple Wire
  • Fluid Temperature Sensor
  • 50ft length of 3/8" Heated Hose
  • 10ft length of Whip
  • 50ft length of Scuff Jacket

2000/3500 psi 300ft Hose System (high flow)

  • Two 50ft lengths of 1/2" Heated Hose with Thermocouple Wire
  • Three 50ft lengths of 3/8" Heated Hose with Thermocouple Wire
  • Fluid Temperature Sensor
  • 50ft length of 3/8" Heated Hose
  • 10ft length of Whip
  • 50ft length of Scuff Jacket

http://www.cpifoam.com/images/hose-setup.jpg

 

 Back to Top